Refer to the exhibit.
You are preparing to perform an upgrade on an unconfigured VPLEX Metro. When you run the ndu pre-check command, it indicates that it has failed and there are no first upgraders. In your troubleshooting, you run the version -a command.
Based on the output, what is the reason for the failure?
Click on the calculator in the upper left corner. How much distributed storage can be managed by a 20 GB logging volume?
Refer to the exhibit.
You are preparing to upgrade a VPLEX Metro system. You ran the version command to begin the verification process and received the output shown.
What is the most likely reason for the warning?
According to EMC best practices, how many metadata volumes for a VPLEX Metro configuration are required on each cluster?
Refer to the exhibit.
During a short power disruption to cluster 2, director-2-1-A had failed. Power was restored after 5 minutes. In examining the output of the vault status command, you note that cluster-2's status reads "Cluster is not vaulting/unvaulting".
Why did this message appear?
Which type of statistics is used to track latencies, determine median, mode, percentiles, minimums and maximums?
Do virtual volumes need to be taken off-line prior to upgrading VPLEX software, and why or why not?
You are doing a code upgrade on a VPLEX. In which directory do you put the upgrade files in order to execute the code upgrade?
A VPlex administrator claims a 100GB Storage Volume that is thin provisioned on the storage array and has 25GB physically allocated and creates a 1:1 encapsulated virtual volume. After a local data mobility job for that Virtual Volume, the storage array administrator notices that the allocated capacity has increased to 100GB.
Why did this happen?
What are the three components that a drill-down command can be run against to provide a more detailed analysis?
A customer wants to refresh the underlying array that comprises one-half of their local RAID-1 mirrors. Their intent is to remove the discarded mirror from VPLEX control, but as a rollback procedure, they want to ensure the detached device is a consistent copy of the original data. What is the proper way to perform this operation, meeting the customer's requirements?
A customer has purchased a dual engine VPLEX Metro cluster. During installation, there are not enough free SAN ports to connect all WAN-COM ports to the SAN. What is the recommended approach?
Refer to the exhibit.
After a power disruption of 20 seconds in a VPLEX environment, the output of the "vault status" command shows no vaulting processes.
Why did this occur?
Refer to the exhibit.
You are implementing a VPLEX Metro configuration, and some BE ports are not logged into the fabric.
Which VPLEX command should be performed?
Refer to the exhibit.
What is the function of the two highlighted VPLEX VS2 modules?
Refer to the exhibit.
During a short power disruption to cluster 2, director-2-1-A failed. Power was restored after 5 minutes. In examining the output of the vault status command, you note that cluster-2's status reads "Cluster is not vaulting/unvaulting".
Why did this message appear?
Refer to the exhibit.
You are performing a health-check on a VPLEX VS2 Metro system. After running several commands, you notice port errors on the VPLEX directors.
What does the information listed under Checking ports status indicate?
Refer to the exhibit.
You have created a Distributed Device in a VPLEX Metro. You want to confirm you have chosen the correct volumes before performing a device mobility job within cluster-2. Which object will be the source for this operation?
Refer to the Exhibit.
Based on this diagram of a single VPLEX engine, which protocol is represented by "A"?
Implementation Engineer | E20-260 Questions Answers | E20-260 Test Prep | VPLEX Specialist Exam for Implementation Engineers Questions PDF | E20-260 Online Exam | E20-260 Practice Test | E20-260 PDF | E20-260 Test Questions | E20-260 Study Material | E20-260 Exam Preparation | E20-260 Valid Dumps | E20-260 Real Questions | Implementation Engineer E20-260 Exam Questions