HPE2-W09 Aruba Data Center Network Specialist Exam Questions and Answers

You want to use NetEdit to configure an AtubaOS-CX switch.

Is this a minimum requirement for setting up communications between the switch and NetEdit?

Solution:Make sure that the SSH server is enabled.

Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?

Solution:To reduce the amount of traffic sent over the ISL between Switch-1 and Switch-2. enable Equal Cost Multi Path (ECMP) on both Switch-1 and Switch-2.

Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer(AFC) is integrated with Nutanix?

Solution:Automated provisioning of LAGs Between AHV and VSX

Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer(AFC) is integrated with Nutanix?

Solution:Automated configuration of Layer 3 MP-BGP protocol on leaf switches

Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches' link-up delay settings?

Solution:Set the link-up delay timerbased on the number of MAC forwarding, ARP, and routing table entries.

Is this correct positioning of AtubaOS-CX switches in the data center?

Solution:Aruba CX 6300 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).

Is this a guideline for establishing a Virtual Switching Extension (V5X) Inter-Switch Link (ISL) between two ArubaOS-CX switches?

Solution:Use the same speed on every link In the ISL.

A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX)at the core?

Solution:The aggregation layer operates at Layer 2 only, and the core provides Layer 2 and Layer 3 functions.