AP0-001 Acme Packet Certification Certification Exams Boot camp & Braindump Questions and Answers

registered

agents-only

realm-prefix

prev-registered

sec-utility-address

pri-utility-addr

ip-address

arp-address

send PING messages to dynamically learn the binding time of a endpoint behind a NAT device

send OPTIONS methods at a defined incrementing period to dynamically see if an endpoint behind a NAT device is still reachable

create bindings for the Addresses of Record of endpoints that are not behind a NAT

create bindings for the Addresses of Record of endpoints that are behind a NAT

Identifier

Host

mib-system-name

target

gatekeeper

gateway

multipoint control unit

codec

When the status LED, which is located on the front of the chassis control panel is lit yellow, it is an indication that the Net-Net system is experiencing a major malfunction such as a power supply failure.

You can have up to two simultaneous console connections.

By default, you can only Telnet to the wancom0 interface on the Net-Net 4000.

By default, the Net-Net 4000 media interfaces will respond to PING.

The stage at which the Net-Net 4000 will start tunneling H.245 messages

The point in the call where H.245 messages are allowed, given that the call has been connected

The stage at which the Net-Net 4000 will indicate that a separate H.245 connection must be opened or will react to an external indication to open a separate H.245 connection

The point at which H.245 will appear on stage

Establishment, modification and termination of multimedia sessions.

Provides resource reservation for multimedia sessions.

Supports redirection services.

Describes the supported media attributes for the session.

Add the remote device IP address to the hip-ip-list and the telnet-ip-address fields to allow it Telnet access.

Set the telnet-ip-address field to enabled.

Add the IP address of the interface in the hip-ip-list and the telnet-ip-address fields.

Do nothing. Telnet is supported by default on all interfaces.

You must have a minimum of three realms in any configuration as one realm must be designated as the home realm.

All endpoints within a realm must reside within the same subnet as the Net-Net 4000.

Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP-interface per realm.

You can associate multiple realms with a single network interface.

Logs

CDRs

Boot parameters

Backup configurations

1024

6000

999

4095

Via

From

SDP

Contact

Wancom0

Wancom1

Wancom2

Wancom3

Use the exec last-known good config command

Use the rollback command

Use the restore-backup-config command

None of the above

sec-utility-address

pri-utility-addr

ip-address

arp-address

There are two fans, each with configurable speed control.

The fan module is field upgradeable.

The fan speed is automatically adjusted to the appropriate level based on the current operational status and system environment.

The fan module can move the air a total of 30 cubic feet per minute.

The element you are creating is corrupted.

The element you are trying to save doesn't exist.

You are trying to create an element with a unique identifier that already exists.

There is an internal server error.