A version 9 SteelCentral Controller for SteelHead (SCC) connects to managed appliances using which protocols?
You would like to upgrade a Virtual SteelHead VCX755-L to VCX755-H. What is required to permit the upgrade to succeed? (Choose three.)
-- Exhibit –
-- Exhibit --
Refer to the exhibit. According to the screenshot, what does the highlighted symbol represent? (Select 2)
Log messages in the Steelhead appliance Management Console such as “error=SMB_SHUTDOWN_ERR_SEC_SIG_ENABLED” are an indication of what condition?
True or False? To be able to use Active Directory assignments, the SteelCentral Controller for SteelHead Mobile must be joined to the domain.
-- Exhibit –
-- Exhibit --
Refer to the exhibit. The connections from USER1 to Server3 are not being optimized. What is the possible cause? (Select 2)
-- Exhibit –
-- Exhibit --
Refer to the exhibit. According to the packet capture, what statements are true? (Select 2)
Once a SteelHead is registered for Cloud (SaaS) optimization it contacts the Cloud portal every 5 minutes to receive the latest information about the service. What would happen if a Firewall change stops the HTTPS communication with the Portal?
Authentication fails for certain users after configuring the Server-Side Steelhead Appliance to be a RODC. What could be the issue?
You wish to utilize a SteelHead to fill a high bandwidth, high latency WAN link without data reduction. The link is 622mbps and 500ms latency. What steps should you take to fill the pipe?
Consider a SteelHead deployment with SMB optimization and SMB signing enabled on all SteelHeads. The client is configured to have signing enabled and the server has signing disabled. What will happen to SMB connections between these two hosts?
The Steelhead Mobile client on your laptop is showing a status of “Firewalled”. What is the problem?
The Interceptor appliance will attempt to redirect a connection to a Steelhead appliance in the auto pool:
When upgrading a Virtual Steelhead appliance, what steps can be taken to preserve the existing datastore?
A user downloads a Microsoft Excel document from a server over an optimized connection. The transfer is very fast. The user makes some changes to the spreadsheet and then saves the document. The transfer is very slow. The user edited a Word document shortly before but that downloaded and saved at the same fast speeds. What happened to the Excel document?
You can monitor your Steelhead appliance disk performance using which reports? (Select 2)
The primary purpose of setting proxies (found on Networking – Proxies) on the Interceptor is to:
What type of reporting information will an Interceptor appliance store? (Select 2)
What are the possible ways to downgrade a Virtual Steelhead appliance after it has been upgraded?
What information does the OVA package include about the Virtual Steelhead appliance? (Select 4)
Refer to the exhibit.
If Server A is an FTP server, which setting will enable active FTP optimization on Steelhead Mobile Client R?
Refer to the exhibit.
If Steelhead Mobile Client B offers up a share on the network, what is needed on Steelhead Mobile Client R to open an optimized connection to this share if enhanced auto-discovery is enabled on all Steelhead appliances?
Refer to the exhibit.
In the accompanying exhibit, SH3 and SH4 are able to optimize FTP and HTTP sessions between Client41 and the respective application hosts Server31 and Server32. However, optimization does not happen for Client42 and these application hosts. A quick check on SH3 and SH4 registers neither optimized nor pass-through traffic from Client42. Client42 is able to ping Client41 and the in-path address of SH4. Note that SH3 and SH4 are in auto-discovery mode. What is the likely cause?
When using TACACS+ or RADIUS to authenticate management access to the CMC appliance, which of the following is true?
Given four Steelheads are deployed in a WCCP cluster and all Steelheads are optimizing traffic to and from the data center. Steelhead-A fails and only Steelhead-B and Steelhead-C are intercepting new connections while Steelhead-D is NOT optimizing any traffic. What is the likely problem?
Which of the following is true about fetching Steelhead appliance's configurations from a CMC appliance?
In an in-path deployment, if a naked SYN packet arrives on the WAN interface of Steelhead, what probe option is added to this SYN packet for auto-discovery?
How many in-path rules will a LAN-initiated (i.e. SYN packet arrives at a LAN port of an In-path interface) single connection match on an Interceptor appliance?
The default setting for “allow failure” in the Interceptor appliance version 2.0 is: (Select 2)
You have an existing Steelhead appliance deployment which is achieving excellent optimization at five sites. You have deployed a Steelhead appliance physically in-path at a new small branch office and many of the new branch office users' applications are unoptimized; however some of the new branch office users' access to the same applications are optimized. None of the Steelhead appliances are in admission control. What is the likely cause?
Which of the following methods can be used to reduce the load on a router configured to use outbound interface WCCP redirection? (Select 3)
In an implementation using a 4-port card, which interface could be used as the Connection Forwarding neighbor? (Select 2)
Which of the following statements are true about server-side out-of-path deployments? (Select 4)
In a previously optimized environment, users have recently upgraded their Windows XP workstations to Windows 7. After the upgrade, users are complaining about slow CIFS and encrypted MAPI performance. What is the most likely cause?
Refer to the exhibit.
The customer would like to prevent a “black-holing” situation when using PBR when SH11 goes down. The Steelhead appliances are directly connected to the routers. What options are available to determine state level status of the Steelhead appliance? (Select 3)
Which of the following are valid QoS priority queues for Steelhead appliances? (Select 3)
VSP on the Steelhead EX supports which features of VMware virtual machines? (Select 3)
Refer to the exhibit.
In order to achieve optimization using auto-discovery for traffic coming from site C and destined to site A in the exhibit, which configuration below would be required?
What is the primary purpose of Connection Forwarding in WCCP deployments with multiple Steelhead appliances in a single cluster? (Select 2)
RCPE-CP-WO | 830-01 Questions Answers | 830-01 Test Prep | RCPE Certified Professional WAN Optimization Questions PDF | 830-01 Online Exam | 830-01 Practice Test | 830-01 PDF | 830-01 Test Questions | 830-01 Study Material | 830-01 Exam Preparation | 830-01 Valid Dumps | 830-01 Real Questions | RCPE-CP-WO 830-01 Exam Questions
TESTED 27 Dec 2024
