EX407 Red Hat Certified Specialist in Ansible Automation exam Questions and Answers

===================================================================================

control.realmX.example.com _ workstation.lab.example.com

node1.realmX.example.com _ servera.lab.example.com

node2.realmX.example.com _ serverb.lab.example.com

node3.realmX.example.com _ serverc.lab.example.com

node4.realmX.example.com _ serverd.lab.example.com

node5.realmX.example.com

- username:root, password:redhat

- username:admin, password:redhat

note1. don’t change ‘root’ or ‘admin’ password.

note2. no need to create ssh-keygen for access, its pre-defined

note3. SELinux is in enforcing mode and firewalld is disabled/stop on whole managed hosts.

===================================================================================

Create and run an Ansible ad-hoc command.

--> As a system administrator, you will need to install software on the managed

nodes.

--> Create a shell script called yum-pack.sh that runs an Ansible ad-hoc command to

create yum-repository on each of the managed nodes as follows:

--> repository1

-----------

1. The name of the repository is EX407

2. The description is "Ex407 Description"

3. The base URL is http://content.example.com/rhel8.0/x86_64/dvd/BaseOS/

4. GPG signature checking is enabled

5. The GPG key URL is http://content.example.com/rhel8.0/x86_64/dvd/RPM-GPG-KEYredhat-

release

6. The repository is enabled

--> repository2

-----------

1. The name of the repository is EXX407

2. The description is "Exx407 Description"

3. The base URL is http://content.example.com/rhel8.0/x86_64/dvd/AppStream/

4. GPG signature checking is enabled

5. The GPG key URL is http://content.example.com/rhel8.0/x86_64/dvd/ RPM-GPG-KEYredhat-

release

6. The repository is enabled

In /home/sandy/ansible/ create a playbook called logvol.yml. In the play create a logical volume called Iv0 and make it of size 1500MiB on volume group vgO If there is not enough space in the volume group print a message "Not enough space for logical volume" and then make a 800MiB Iv0 instead. If the volume group still doesn't exist, create a message "Volume group doesn't exist" Create an xfs filesystem on all Iv0 logical volumes. Don't mount the logical volume.

Create a file called adhoc.sh in /home/sandy/ansible which will use adhoc commands to set up a new repository. The name of the repo will be 'EPEL' the description 'RHEL8' the baseurl is 'https://dl.fedoraproject.org/pub/epel/epel -release-latest-8.noarch.rmp' there is no gpgcheck, but you should enable the repo.

* You should be able to use an bash script using adhoc commands to enable repos. Depending on your lab setup, you may need to make this repo "state=absent" after you pass this task.